Configuration
To control your blinds automatically you have to assign them to a facade. you can do that in the parameter panel of an existing facade under „elements“.
ATTENTION! Blinds should not be assigned to several facades. Take care of blind groups too.
If you also want to use the shading control to use heat of the sun, you can add the inside temperature under „thermostats“. You can also leave this area empty, if you do not want to enable heat using.
On the bottom of the parameter panel you can see a table with control positions. This table is the base of the shading control. You can set blind positions to a specific sun height and also the angle at jalousies.
With the „submit“ button you can accept the set values to the facade. You can also set the values to all facades or reset it to default values.
On the bottom of the parameter panel you can set additional parameter. The minimal brightness must be above to control the blinds by the table. Among this value the blinds keeps open.
If the heat protection is active, all blinds will close completely, if the outside temperature is above the setting.
On using a thermostat and heat using is active, all blinds will open completely, if the outside temperature and inside temperature is among the setting.